Open the Klipper Firmware Configuration screen using the following command: make menuconfig The Klipper Firmware Configuration screen will appear. Using your navigation keys, move through the menus and replicate the same settings I used. When finished, press Q then Y to save your configuration.Messages: 17,048. Been trying to print a bookshelf speaker box side panel using black eSun PLA+ at 210C with 60C bed temp 40mm/s feed rate. The panel is 210mm x 155mm x 8mm with a 0.2mm layer height and 10% infill. When it cools and I remove the panel from the hot bed, it's. WIMAXIT M1331C 13.3Inch IPS HDR Portable USB-C HDMI Monitor Ultra Thin Build in Speaker Gaming Monitor for Laptop,Cellphones.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |